Tyre Blowouts: Do’s & Don’ts You Should Know About

Technology

Though a rare event, tyre blowouts do occur unexpectedly which is a daunting experience and can turn to be potentially dangerous if you’re clueless on how to deal with it. There’re many different ways to reduce the likelihood of tyre burst but, drivers need to be prepared for the worst should there be an occurrence. To remain calm, maintain full control of the vehicle and safely pull to a side is the best thing to do however, it’s easier said than done. Let’s have a look at how to best manage tyre blowout and get moving again so here’re a few do’s and don’ts.

Don’t Ignore the Tyres

Like many other things, prevention is better than cure. Often unexpected, improper maintenance of the tyres is a common reason for flats or tyre blows. It’s obvious that we often drive up the curbs or over the potholes every by and over but, such carelessness and negligence of the tyres for longer would only make things worse, leading to a disaster.

Regular checking of the tyres that includes the spare, ensures they’re in working order and safe for the road. Once the tyres have covered a certain mileage and travelled long journeys, it’s likely they’ve experienced cuts, rips and bulges. In case the tyre has been damaged, better take it to an expert who’d know if they need repair or replacement.

Pressure & Tread Depth

Improper tyre inflation may result in failure which is why you should perform regular checks using a pressure gauge to ensure just the appropriate air/gas level. Keep a balance between over-and-under-inflation or simply refer to the manufacturer’s specification to maintain appropriate air pressure. These details can be found on the driver’s door, under the fuel cap as well as the vehicle’s manual. Do note that pressure would vary per the load your car can bear or currently carrying.

Then there should be a close check on the tread depth as well with minimum legal limit of 1.6mm over the mid-three quarters of the tyre and its diameter. Just in case it reaches the defined limit or drops below it, your car tyres in Lebanon need to be replaced.

Don’t Slam the Brakes

In case one of the tyres give way all of a sudden, you’d be tempted to hit the brakes immediately but, experts actually don’t recommend this action for it’s more dangerous and make you lose control on the car. Simply ease off the brakes, let the burst tyre drag bring your car to a slow and natural stop whereas you might just need to apply gentle acceleration to keep the vehicle steady. All of this might sound absurd but a full-blown tyre would naturally slow down the vehicle. And when the car is stable, use the engine braking by shifting into lower gear if it’s crucial.

Drive Straight

Quickly turning the steering wheel after the blowout would probably get the car to spin out of control especially if the occurrence happened at the rear. So, all you need to do is keep the vehicle moving straight and avoid the temptation to veer off course.

Leave a Reply